Teltonika Rut956 Dual Sim 4G Lte Router With Serial Io And Ethernet

TELTONIKA RUT956 DUAL SIM 4G/LTE ROUTER WITH SERIAL, IO AND ETHERNET

Teltonika RUT956 Dual SIM LTE Router with Serial, IO and Ethernet. RUT956 is an industrial router that combines cellular, Wi-Fi, and wired connectivity options with automatic WAN failover and GNSS capabilities. Serial communication interfaces enable integrating more varied devices into the solution ecosystem, while I/O and advanced RutOS software facilitate equipment control, automation, and event notifications.

FEATURES

4G LTE (Cat 4), 3G, 2G

Dual SIM With auto failover, backup WAN and other switching scenarios

Multiple Interfaces - Ethernet, Serial (RS232, RS485) and multiple Inputs/Outputs

GNSS Global Navigation Satellite System for location services and time synchronization

SPECIFICATIONS

Product code: RUT956700000

Mobile module: 4G (LTE) – Cat 4 up to 150 Mbps, 3G – Up to 42 Mbps, 2G – Up to 236.8 kbps

SIM switch: 2 SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail, SIM idle protection

CPU: Mediatek MIPS 24Kc 580 MHz

RAM: 128 MB, DDR2

FLASH storage: 16 MB, SPI Flash

Status: Signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO, RSCP, Bytes sent/received, connected band, IMSI, ICCID

GNSS: GPS, GLONASS, BeiDou, Galileo and QZSS

SMS: SMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to EMAIL, SMS to HTTP, SMS to SMS, scheduled SMS, SMS autoreply, SMPP

USSD: Supports sending and reading Unstructured Supplementary Service Data messages

Black/White list: Operator black/white list

Multiple PDN: Possibility to use different PDNs for multiple network access and services

Band management: Band lock, Used band status display

APN: Auto APN

Bridge: Direct connection (bridge) between mobile ISP and device on LAN

Passthrough: Router assigns its mobile WAN IP address to another device on LAN

Wireless mode: IEEE 802.11b/g/n, Access Point (AP), Station (STA)

WiFi security: WPA2-Enterprise - PEAP, WPA2-PSK, WEP, WPA-EAP, WPA-PSK; AES-CCMP, TKIP, Auto Cipher modes, client separation

Ethernet WAN: 1 x WAN port 10/100 Mbps, compliance IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX

Ethernet LAN: 3 x LAN ports, 10/100 Mbps, compliance IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX

Routing: Static routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, NHRP)

Network protocols: TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet, SMPP, SMNP, MQTT, Wake On Lan (WOL)

VoIP passthrough support: H.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets

Connection monitoring: Ping Reboot, Wget Reboot, Periodic Reboot, LCP and ICMP for link inspection

Firewall: Port forward, traffic rules, custom rules

VPN: OpenVPN, OpenVPN Encryption, IPsec, GRE, PPTP, L2TP, Stunnel, DMVPN, SSTP, ZeroTier, WireGuard

Modbus: MODBUS TCP SLAVE, MODBUS TCP MASTER, MODBUS RTU MASTER (RS232), MODBUS RTU MASTER (RS485), MODBUS DATA TO SERVER

MQTT Gateway: Allows sending commands and receiving data from MODBUS Master through MQTT broker

TR-069: OpenACS, EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech, AVSystem

Input: 1 x digital dry input (0 - 3 V), 1 x digital galvanically isolated input (0 - 30 V), 1 x analog input (0 - 24 V), 1 x Digital non-isolated input (on 4-pin power connector, 0 - 5 V detected as logic low, 8 - 30 V detected as logic high)

Output: 1 x digital open collector output (30 V, 250 mA), 1 x SPST relay output (40 V, 4 A), 1 x Digital open collector output (30 V, 300 mA, on 4-pin power connector)

Power Connector: 4-pin industrial DC power socket

Input voltage range: 9 – 30 VDC, reverse polarity protection; surge protection >31 VDC 10us max

PoE (passive): Passive PoE over spare pairs. Possibility to power up through LAN port, not compatible with IEEE802.3af, 802.3at and 802.3bt standards, Mode B, LAN1 Port, 9 - 50 VDC

Power consumption: < 2 W idle, < 7 W Max

Operating temperature: -40 °C to 75 °C

Operating humidity: 10% to 90% non-condensing

Ingress Protection Rating: IP30

Standards: EN 301 489-1 V2.2.3, EN 301 489-17 V3.2.4, Draft EN 301 489-19 V2.2.0, Final draft EN 301 489-52 V1.2.0, EN 55032:2015+A1:2020, EN 55035:2017+A11:2020, EN 61000-3-3:2013+A1:2019, EN IEC 61000-3-2:2019

PACKAGE CONTENTS

1 x Teltonika Rut956 Dual Sim 4G Lte Router With Serial Io And Ethernet
1 x 9 W PSU
2 x LTE antennas (magnetic mount, SMA male, 3 m cable)
2 x WiFi antennas (magnetic mount, RP-SMA male, 1.5 m cable)
1 x GNSS antenna (adhesive , SMA male, 3 m cable)
1 x RS485 connector block
1 x I/O connector block
1 x Ethernet cable (1.5 m)
1 x SIM Adapter kit
1 x QSG (Quick Start Guide)